Well Pump Repair & Replacement in Western North Carolina

Well Pump Repair & Replacement

The pump is the one part of your well system that does the work, and when it fails you usually find out the hard way: no water, sputtering taps, or pressure that limps along. We diagnose and repair submersible pumps down in the well and jet pumps at the surface, test the motor, the wiring and the water level, and replace the pump only when it has truly failed. On deep mountain wells we pull and reset pumps on poly drop pipe, replace torque arrestors and check valves, and size the new pump to the depth and yield of your well so it does not run dry or short-cycle. Lightning strikes and power surges, common on ridge lines, are another frequent cause of a dead pump here, and we check for that too.

What a failing pump looks like

Pumps rarely die all at once. The warning signs are air in the lines, pressure that never reaches the top of its range, the pump running far longer than it used to, a breaker that trips, or an electric bill that jumped. Sand or grit in the water can mean a worn pump or a well drawing down past the intake. We measure amperage and water level to tell a worn pump apart from a wiring fault, a stuck check valve or a low-yield well.

Repair first, replace when it makes sense

Not every pump problem is a dead pump. We repair wiring, splices, control boxes, check valves and torque issues, and we replace the pressure switch or relay when that is the real fault. When the pump itself is gone, we pull it, inspect the drop pipe and wire on the way up, install a correctly sized replacement, and disinfect the well before we put it back in service.

Sized for deep, low-yield mountain wells

A pump that is too big for a slow well will pump it dry and burn itself up; one that is too small will never build pressure on a 600-foot setting. We size by depth, yield and household demand, and on very slow wells we will talk through a low-yield pump controller or a storage tank instead of just hanging a bigger pump.

What’s included

• Submersible and jet pump diagnosis and repair
• Motor, wiring, splice and control-box testing
• Check valve, torque arrestor and drop-pipe service
• Pump sized to your well depth, yield and household demand
• Lightning and surge damage checks
• Well disinfection before the system goes back in service